Iata varianta de ptocesare ai managemnt pentru procesarea FM. Pentru prima data nu mai exosta compromis.
Omnia 9 contine in unele cazuri mai mult decat e nevoie pentru o emisie FM fara probleme.
caracteristici
- Simultaneous separate processing cores for FM and HD and (Optional) HD2/HD3 (see model 2001-00293).
- Each processing core is separately fully adjustable and has selectable 4, 5, 6 or 7 bands.
- Psychoacoustic Composite Embedder allows up to 140% audio peaks in stereo at 100% total modulation.
- Contains exclusive "Undo" technology, a source declipping algorithm and program-adaptive multiband expander which removes distortion from source material. This corrects over-processed CDs, so common in today's contemporary music.
- Multiband downward expansion (source noise reduction). 3-stage wideband AGC with adjustable sidechain equalization.
- Program-dependent multiband compression.
- Multiband look-ahead limiting.
- Adjustable dynamic bass clipping.
- Selectable phase linear high pass filter, 15, 30 or 45 Hz.
- (For Digital) Two-band final look-ahead limiting. Selectable phase linear (high latency) or low latency (talent air monitoring capable) modes.
- Fully automatic program-dependent declipper and multiband expander for damaged content such as loud CDs.
- Streaming encoding built in for Primary Digital (HD) and (Optional) Secondary (HD2) and Tertiary (HD3) - (see model 2001-00293).
- Supports encoding to MP3 (Mpeg-1 Layer 3), MP2 (Mpeg-1 Layer 2), AAC, HE-AAC (including RTSP/3G for streaming to mobile phones), Ogg Vorbis, WMA and WMA Pro. 7 inch front panel touch screen.
- Full remote control.
- On-screen keyboard with several layouts (QWERTY, QWERTZ, AZERTY, Dvorak and ABC sequential) for easy setup and preset name typing.
- RDS encoder, dynamically updateable.
- Selectable SSB (Single Sideband) stereo encoder. HTTP push support for automation, such as dynamic RDS and streaming song titles, preset recall.
- Dayparting (scheduled preset selection).
- Studio Output with very low latency for talent monitoring.
- Dual independent power supplies.
- Composite pass-through (relay bypass) for your backup processor.
-
Specifications
- Frequency Response +/-0.5dB 20Hz to 15kHz, 17.5kHz in extended mode
- Signal-Noise Ratio Greater than -80dBu de-emphasized, 20Hz to 15kHz
- System Distortion Less than 0.01%
- THD below pre-emphasis, inaudible above Stereo Separation 65dB minimum, 20Hz to 15kHz, 70dB typical
- Digital Output Level Adjustable from -24.0dBFS to 0.0dBFS in 0.1dB increments
- Stereo Baseband Output Adjustable from -2dBU to +22dBU (0.1dB increments) into 600-Ohms, 20-Ohm output impedance A/D
- Conversion Crystal Semiconductor CS5361, 24 bit 128x over-sampled delta sigma converter with linear-phase anti-aliasing filter.
- Pre-ADC anti-alias filter, with high-pass filter at <10 Hz
- D/A Conversion Crystal Semiconductor CS4391, 24-bit, 128x oversampled External Sync Input Per AES11
- Digital Audio Reference Signal (DARS), reference for digital output sample rate.
- External Sync Range 32kHz to 96kHz Analog I/O Two balanced, EMI filtered XLR connectors
- Stereo Generator Connections Four 75-Ohm BNC female, two inputs, two outputs (FM style only) AES/EBU In & External Sync XLR-female AES/EBU Out Four XLR connectors for Main and Aux Digital programs (two stereo in, two stereo out)
- Ethernet/Livewire Shared RJ45 supporting 100 and 1000 BASE-T Ethernet connections
- Power Requirements 100-264 VAC, 47-63Hz autosensing
- Power Connector IEC male, detachable 3-wire power cords supplied
- Power Supply Internal dual redundant, hot-swappable
- Environmental Operating: 0 to 50 degrees C Non-operating: -20 to 70 degrees C.
- Europe: Designed to comply with the requirements of Low Voltage Directive 73/23/EEC and EMC Directive 89/336/EEC.
- Designed for RoHS and WEEE compliance.
- Dimensions 3RU
